Quick Device Specs
Samsung Galaxy A50 is a mid-range smartphone with a premium design, Super AMOLED screen, an in-display fingerprint reader, a triple camera, and a large battery. The phone features a 6.4-inch Super AMOLED screen with Full HD+ resolution, 19.5:9 aspect ratio, and a U-shaped notch. It features a 25MP selfie camera with an f/2.0 aperture. There is a triple-camera setup at the rear, which consists of a 25MP sensor, an 8MP sensor, and a 5MP sensor that can record 4K videos. There is a 25MP selfie camera at the front. The Galaxy A50 runs Android 9 Pie-based One UI and uses the Exynos 9610 chipset. The phone has GPS, a dual-SIM card slot, 4G connectivity, dual-band Wi-Fi ac/b/g/n, Bluetooth 5.0, NFC, a USB Type-C port, and a 3.5mm headphone jack. It lasts long, too, thanks to a 4000mAh battery which supports 15W fast charging.
Fix, Galaxy A50 Keeps Losing Signal
Verify signal strength
In a lot of network issues, poor or weak signal is to blame. If your Galaxy A50 is showing No Service all the time recently, be sure to check how the signal bars are showing on your device. Anything lower than 3 bars is not good and can indicate a network issue.
If you are inside a building, try to go out and see if No Service goes away. If you are traveling by car, it’s possible that you may be transiting a dead spot. What you want to do is to move a known well-covered area. If No service remains, there may be an issue with your Galaxy A50. Continue troubleshooting it by following the steps below.
Simple Reboot or Forced reboot
Well, I think you already know how to restart your phone. So just restart the device and see whether it solves the issue or not. Restarting a device is always an ultimate solution for any issue. Not only Galaxy but this applies to each and every electronic device. I used to tell my mom to restart her device if she faces any issue with her smartphone.
Well if you still need to know how to restart then, here is it: Press your phone’s power button. On the screen, tap Restart.
The other way of the reboot is as follows:
- Press and hold the Volume Down button.
- While holding it down, press and hold the Power key.
- Keep the button held for 10 seconds, it will be restarted automatically.
If this doesn’t work then head to the next method.
Rebooting your device regularly at least once every week can be beneficial. If you tend to forget things, we suggest that you configure your phone to reboot on its own. You can schedule it to do this task by doing these steps:
- Open the Settings app.
- Tap Device Care.
- Tap the 3-dot at the top.
- Select Auto restart.
Remove and Reinsert SIM card
I don’t think you need another tutorial to reinstall a sim card in your device. Just remove the sim tray from the device and restart the device and then reinsert it to the device.
- Activate the flight mode.
- Push Sim eject tool into the circular opening on the SIM card tray to remove it.
- Power off the device.
- Remove the Sim card from the Sim tray then place it back in.
- Push the tray back into the slot.
- Boot the device.
Once you’ve removed the SIM card from the device, wait for a few moments before re-inserting it. This has the effect of refreshing the system without the old cellular settings. Once the SIM card is re-inserted and the phone restarted, your network’s configuration should be added automatically.
If you have another phone that can work with your network, you can also try to insert the SIM card to it. This will help you check if there’s an issue with the SIM card itself. If the problem returns when you use the SIM card in the second device, you either have an issue with the SIM or with the network. Try getting a new SIM card to see if it’s the SIM or the network.
Reset Network Settings
- Open Settings from either Quick Nav menu or the launcher.
- Scroll down and tap on General management.
- Then tap on Reset.
- Finally, tap on Reset network settings.
- Then tap on Reset settings.
- Confirm with your lock screen password when prompted.
Install carrier updates
One way in avoiding network troubles is to ensure that you install system updates as they come. If you got your S20 from your carrier and you haven’t modified the software at all, all you need to do is to tap on the notification if there’s any update. Network issues unique to your network operator are usually fixed by updates.
Change network mode
Sometimes, changing a device’s network mode from, say, 4G LTE to 3G can get rid of network problems. If you haven’t tried doing this as of this point, here are the steps to follow:
- Open the Settings app.
- Tap Connections.
- Tap Mobile networks.
- Tap Network mode and select 3G or 2G.
- Restart the device and repeat steps 1-3.
- Tap 4G or LTE or auto-connect to return to the original configuration.
Manually disconnect from the network
- Open the Settings app.
- Tap Connections.
- Tap Mobile networks.
- Tap Network operators.
- Tap Select manually.
- Wait for your device to search for networks.
- Once it’s done searching,, select another network to connect to. For example, if you’re on T-Mobile, pick AT&T or any other network.
- Your phone will be forced to return with an error because it won’t be able to register successfully.
- Afterward, select your own network again and see if your device will now be able to re-register and fix the bug.
Clear Cache from Recovery Mode
In case you don’t know what is recovery, the first thing the bootloader rings up is the recovery. Recovery Mode refers to a special bootable partition, which contains a recovery application installed in it. And you can fix some problems with your phone. Follow the steps to clear cache from recovery mode:
- Turn off your phone.
- Once it is turned off. Press and hold the power/Bixby and volume down button simultaneously until the Android logo pops up.
- When the green Android logo displays, release both buttons.
- The Recovery screen menu will now appear
- Use the Volume button to go to Wipe Cache Partition then press the Power button to confirm the selection.
- Wait until your device wipes out all cache or temporary data from the system partition.
- Press the Power button again to reboot the device.
This clears all the temporary data from the device. And then it works like new.
Troubleshoot apps in Safe Mode
In case you don’t know what is safe mode, in safe mode, the system temporarily disable all third-party applications you installed on your device. By doing this we can figure out which app is occurring the problem. Follow the below step to turn Safe Mode on:
- Turn OFF the device.
- Press and hold your device’s Power button till the model name screen.
- When the SAMSUNG logo appears on the screen, release the Power key.
- Immediately after releasing the Power key, press and hold the Volume down key.
- Continue to hold the Volume down key until the device finishes restarting.
- Safe mode will display in the bottom left corner of the screen.
- Release the Volume down key when you see Safe Mode.
After figuring out the apps which are creating the problem, follow the below steps to uninstall it(if required):
- Open Settings from Launcher.
- Tap on Apps.
- Tap See All Apps.
- Tap an app that you want to uninstall
- Tap Uninstall.
- Tap OK to confirm.
Factory Reset
Disclaimer
Factory reset will delete everything, so you want to make sure that you create a copy of your data such as photos, videos, documents, texts, etc. ahead of time.
- Open the Settings from the launcher.
- Scroll to and tap General management.
- Tap Reset.
- Select Factory data reset.
- Tap Reset to continue.
- Tap Delete All to confirm the action.
From Recovery:
- Turn off your phone.
- Once it is turned off. Press and hold the power/Bixby and volume down button simultaneously until the Android logo pops up.
- When the green Android logo displays, release both buttons.
- The Recovery screen menu will now appear
- Use the Volume Down button until you are highlighting ‘Wipe data/factory reset.’
- Press the Power button to select ‘Wipe data/factory reset.’
- Use Volume Down to highlight Yes.
- Press the Power button to confirm the action to clear your phone data.
No Service bug can be caused by an issue from your network operator so you won’t be able to fix it on your end at all. Talk to your carrier and let them check the problem if nothing is fixed after a factory reset.
Conclusion
That was it, this was the easiest way to Fix when Galaxy A50 keeps losing the signal. Follow them carefully to get benefits of the feature in your Galaxy A50. Are you facing any problems and issues with your Galaxy A50? Then there is nothing to worry about, we have an article dedicated to Galaxy A50’s issues and guides. Here is the Galaxy A50 Troubleshooting Guide. Although it’s rare, some cases of the issues on Samsung Galaxy devices may have bad hardware as the origin. If a factory reset won’t help in fixing your issue, visit your local Samsung store or Service Center so a qualified Samsung technician can examine the hardware. If needed, they may send it in for repair or replacement.
Do you own a Galaxy Device, or any Android device and need these types of simple tutorials? Then stay tuned to GetDroidTips’ Android Tips & Tricks column because many simple tutorials for Galaxy are coming soon.
If you have any queries regarding this, the comment section is always available for you.
Galaxy A50 Troubleshooting Guide
