The entire phone is made out of “Glasstic” which is just a fancy way of saying frosted plastic. It does feel rather premium thanks to the engineering that Samsung has put into this phone. The Galaxy M31s comes out of the box with Samsung’s OneUI 2.1 that runs atop Android 10. It is expected to receive the latest versions of Android and OneUI as well. The M31s has a quad-camera setup to the rear with a configuration of 64+12+5+5MP which seems to be an overall good setup for taking photos in well-lit situations. The front camera is a 32MP sensor that takes some really crispy selfies.
Check OTA Update
Samsung always releases firmware OTA updates to its eligible devices in batches based on the server or region. So, it’s quite obvious that most of the users may receive the firmware update notification lately. However, it’s recommended to check for OTA updates manually on your device via the phone settings.
- Settings > About phone > Software updates > Check for Updates
- If the new software update is available, then tap Download now.
- Post the download, tap on Install update to begin the installation.
Make sure to connect your device to a Wi-Fi network and fully charge the battery level. If your device gets the latest software update notification, you can simply grab the OTA by downloading and installing it. But if in case, you want to install any particular update version or want to keep updated with each and every firmware update, you should follow the tracker list below.
Samsung Galaxy M31s Stock Firmware Tracker
We will keep updating the firmware update details whenever a new update will be available. So, make sure to bookmark this page. You will find stock firmware for SM-M317F.
Make sure to download the correct firmware for your device. If you are using SM-M317F, then download firmware starting with SM-M317F.
How to Install Stock Firmware on Samsung Galaxy M31s Manually
Ensure to follow all the requirements properly before going to the firmware installation process.
Pre-Requirements:
- Before you go ahead with the procedure, make sure to take a complete backup of your Samsung phone.
- Install the appropriate Samsung Galaxy USB drivers.
- Make sure to charge your device to at least 60%.
- Download the latest version of the Odin tool.
- Make sure to enable USB Debugging:
– To do that again, head to the Settings>>Developer Options>> allow USB Debugging.
- Enter your Galaxy device into the Download mode by pressing Volume Down + Home + Power buttons for Samsung phones with capacitive buttons and Volume Down + Bixby + Power for newer models.
Instructions to Install
- Download the appropriate Galaxy stock firmware for your phone.
- Extract the contents of the firmware zip file.
- Notice that the extracted files will be in “.tar” or “.tar.md5” format.
- Now download and extract the Odin tool on your PC.

- Open the extracted folder and click on the Odin.exe file.

- You need to connect your Galaxy device to the PC while it is in Download Mode.

- Notice that the CO port will light up on Odin once you connect your phone.
- Click the AP button and select the firmware.

- Do the same for BL, CP, and CSC.
- Keep in mind that the regular CSC file will erase the entire data. In order to save the data select the ‘HOME_CSC‘ file.
- Don’t forget to select Auto Reboot and F.Reset Time in the Options tab.

- Click the Start button to install the firmware on your Samsung device.
- That’s it! You will see a PASS message once the installation is complete.

We hope this tracker list and firmware flashing guide was helpful to all the Samsung Galaxy M31s users. If you’ve any queries, you can comment below.