- Connect the speaker to the charger and disconnect it. Disconnect it from the charger so it doesn’t charge while it’s unplugged.
- Make sure the speaker is plugged in. It is simply a matter of pressing the power button.
- Hold the volume + and play while pressing the power button. The speaker will restart after about three seconds.
Fix 3: Clear The Charging Port
A JBL speaker can be damaged by constant exposure to dirt and debris, damaging the internal components. Dirt clogging the charging port makes the speaker unable to perform properly.
The speaker’s charging port can be cleaned by blowing it into it until all debris or dirt is removed. Nevertheless, using a toothpick or any sharp instrument is not recommended to remove dirt. In the meantime, check if you can charge the PartyBox.
Fix 4: Use Different Circuit Board
There is a possibility that your JBL speaker’s motherboard may have some issue that causes it not to charge properly. JBL speakers generally play this way if they come into contact with water.
However, this could cause your problem, and service will be necessary if this is the case. You must take your JBL speakers to a service center if you believe they were accidentally exposed to water.
Fix 5: Try Using a Different Charger
Perhaps the charger you’re using is causing your JBL speakers to not charge properly, due to which you are facing the not connecting to Bluetooth, so there may be an issue with your charger. Hence, the JBL Partybox speaker must be charged from a different source before checking if the Bluetooth issue is fixed.
Fix 6: Defective Batteries
If the battery is damaged, the speaker will not be able to be charged. It is possible to fix the problem by replacing the battery if the battery is the cause of the issue. For this reason, if you are familiar with technical issues or if you don’t have one near you, you should check out your batteries.
It is important to note that overcharging or overheating batteries can damage them. To prevent frequent charging, you must make sure to avoid doing so.
Fix 7: Check If It Is Damaged
Based on the information already discussed, Bluetooth speakers can be easily damaged; therefore, we should handle them carefully. However, you must visit your nearest service center immediately if you find any damage, cracks, or dent on your JBL Party box. It is unfortunate, but we have seen in many cases that a damaged speaker also gets damaged internally due to external damage.
Fix 8: Check The Cable
You might also find that the cable you are using to charge your JBL speakers might have been damaged or cut, preventing it from charging. The last option is to replace your charging cable in this situation, so make sure that you check it thoroughly and replace it if you discover any damage. It will take a few minutes for your JBL speakers to begin charging again once the cable has been replaced.
Fix 9: Go To Service Center
If you cannot resolve any type of issue on your own, please contact your local service center for any issue that you may not be able to resolve on your own. But before that, we recommend you submit a complaint ticket on the official JBL support page. You should go to the nearest service center if it doesn’t work. Nevertheless, if you happen to be lucky enough and your device is under warranty, it might be free to have it repaired.
So, that’s how to fix JBL Partybox not connecting to Bluetooth error. We hope that this guide has been helpful to you. Meanwhile, for more info regarding the error, comment below and let us know.
