It’s powered by an octa-core Qualcomm Snapdragon 855+ SoC, paired with Adreno 640 GPU, 8GB of RAM, 256GB of internal storage (UFS 3.0). Keep in mind that it doesn’t have any storage expandable option. While talking about the cameras, the handset sports dual rear cameras with a primary 12MP camera (wide, f/1.8) and a secondary 12MP (ultrawide, f/2.2) lens. It has an LED flash, Dual Pixel PDAF, OIS, HDR, Panorama, etc.
While the front packs a single 10MP selfie camera with an f/2.4 aperture wide-angle lens that has PDAF, HDR mode, etc. There is no 3.5mm audio jack. It features dual-band Wi-Fi 802.11 a/b/g/n/ac, Bluetooth 5.0, GPS, A-GPS, GLONASS, GALILEO, BDS, NFC, USB Type-C port, USB OTG, etc. The device has a side-mounted fingerprint sensor, an ambient light sensor, an accelerometer, gyroscope, proximity, compass, barometer sensor.
Downgrade Samsung Z Flip One UI 5.0/5.1 to 4.0 | Rollback Android 13 to 12
The entire instructions have been broken down into separate sections for ease of understanding. Follow along in the exact same sequence as mentioned.
STEP 1: Take a Device Backup
To begin with, take a backup of all the data on your device. This is because the below downgrade process might wipe off all the data.
STEP 2: Install Odin
Next up, install the Odin Tool on your PC. This will be used to install the downgrade firmware onto your device.
STEP 3: Download the Rollback Firmware
Likewise, download the rollback firmware for your device. This will help you to downgrade your Samsung Z Flip from One UI 5.0/5.1 to 4.0 i.e. from Android 13 to 12. You could download the Android 13 firmware using the Frija Tool or the Samfirm tool. Just make sure to download the firmware corresponding to your region only.
STEP 4: Boot Samsung Galaxy Z Flip 5G to Download Mode
Along the same lines, you will have to boot your device to the Download Mode. To do so, Power off your device. Then press and hold the Volume Down + Volume Up together and connect your device to the PC via USB cable. As soon as you see the Download Mode, release all the keys. Finally, use the Volume Up key to select the OK option. That’s it. Your Samsung Z Flip will now be booted to the Download Mode.
STEP 5: Downgrade Samsung Z Flip One UI 5.0/5.1 to 4.0
Now that you have carried out the above four steps, you may start off with the downgrade process.
- To begin with, extract the downgrade firmware onto your PC. You should get the AP, BL, CP, CSC, and Home CSC files in the .tar.md5 format.
- Then launch the Odin Tool and connect your device to the PC via USB cable. Make sure that it is booted to Download Mode.
- As soon as the connection is established, Odin’s ID: COM port will be highlighted. This means that the tool has successfully identified your device in the Download Mode.
- It’s now time to load the firmware files to Odin. So first of all, click on the tool’s BL button and load the BL firmware file.
- Likewise, do the same for the AP, CP, and CSC. Do keep in mind that you should load the Home CSC file and not the normal one under the CSC section.
- Once you have loaded all the firmware files, go to the Options section of Odin. Now enable the ‘Auto Reboot’ and ‘F.Reset Time’ options.
- When that is done, hit the Start button and wait for the installation to complete.
- Once done, the tool will display the PASS message and your device will reboot to the Android 12 OS.
- You may now disconnect the device from the PC and close the Odin Tool.
That’s it. These were the steps to downgrade your Samsung Galaxy Z Flip 5G from One UI 5.0/5.1 to 4.0 i.e. from Android 13 to 12. If you have any queries concerning the aforementioned instructions, do let us know in the comments section below. Rounding off, here are some equally useful iPhone Tips and Tricks, PC tips and tricks, and Android Tips and Tricks that deserve your attention.
