Doogee S68 Pro is powered by the MediaTek Helio P70 with a 5.9 inches FHD+ IPS display. The device runs on Android 9.0 Pie out of the box. Within a couple of years, MediaTek devices are growing rapidly as low-range entry-level budget segment Android devices.
The MediaTek chipsets offer better stability in performance, good battery backup, and more. Therefore, if you’re using any MediaTek chipset device and unfortunately or unintentionally you have done the factory reset. In a newer generation of MediaTek devices, if you have done the system reset, you may find the FRP Lock system on your device which is a new security measure provided by Google. You can’t do anything until you sign in or remove the previously used Google ID on your MediaTek device. Now, in that case, if you don’t know the credentials or can’t remember either, you should remove or bypass the FRP lock manually. In order to Remove Google Account or ByPass FRP lock on Doogee S68 Pro, we have provided a full guide. Check out the full article.
Now, let’s take a look at FRP.
What is FRP?
FRP stands for ‘Factory Reset Protection’. It’s a new security feature from Google for the MediaTek-powered devices which activates when you log in with Gmail ID on your device for the first time ever. After it gets activated, the security feature prevents the phone from using until you provide the same Google Account Credentials. Therefore, if you lost your phone and someone fully reset your device to use it, it will ask for credentials. That’s a good move from Google though but if you forget it, you have to follow the below-mentioned steps to remove it.
Now, check out the pre-requirements before going to the download section and installation steps.
Pre-Requirements:
- Supported for: Doogee S68 Pro device only. Don’t try it on other devices.
- You will require a PC/Laptop and a USB cable in order to connect your device with the computer.
- Download SP Flash tool and extract it on your Windows PC/Laptop.
- Scatter File: Download Doogee S68 Pro Stock ROM from here. It’s required to proceed with the FRP removal process.
You can create a scatter file by following this guide.
- Download VCOM Drivers and install it on your PC.
- Download the Doogee USB Drivers on your PC and install it.
- Charge the phone battery up to 60% at least to reduce the occasional shutdown during installation.
After following all the requirements from above, you can go to the steps to remove FRP lock manually.
